About Nordson Service Settings

Nordson Service personnel may modify high-level system settings that the customer cannot see. These settings are hidden from view unless a Nordson representative is logged in.

If you think that you may need to adjust any of the settings described in this section, please contact your Nordson representative.

Nordson Service personnel may change the following settings.

Default System Language

Service Settings For Spray Monitors:

• Faceplate animation type

• Timer, spray output, and Can In Pocket signal polarity

• Fault reset mode

• Trigger mode

• Sampling mode

• Minimum spray output

• Smoothing

• Sample points

• Fault reset mode

• FailSafe mode

• Pressure transducer range

• Trigger LED function

Service Settings For Spray Controllers:

• CleanSpray gun enable

• CleanSpray gun spray frequency

• CleanSpray gun manual wash, auxiliary proximity, and tank level switch polarity

• Lacquer gun driver

• Lacquer gun can sense, index, manual wash, and inhibit switch polarity

• Lacquer gun driver configuration lockout

Service Settings For PRx modules:

• Pressure Control enable

• Pressure Control Fault Band settings

• Temperature Monitor enable

• Belt Speed Monitor enable

• Extended CIP Function setup