Touch the information and setup bar on the appropriate Spray Monitor faceplate.
Select Spray Monitor Configuration from the drop-down menu.
Select the Service button at the top of the Spray Monitor Configuration window.
NOTE: Only Nordson service personnel can access this setting. Contact your Nordson representative if you need to change this setting.
The Trigger Mode tells the OI how the gun will be turning on and off. The type of can you are coating usually determines this setting.
Intermittent: Use when the gun will be cycling on and off at a rapid, regular rate. (Typically used when coating two-piece cans.)
Continuous: Use when the gun will be spraying for an extended period of time. (Typically used when coating lids or the inside stripe of three-piece cans.)
NOTE: You cannot change the trigger mode setting while the system is operating. If you want to change the trigger mode, shut down the system.
Touch the information and setup bar on the appropriate Spray Monitor faceplate.
Select Spray Monitor Configuration from the drop-down menu.
Select the Service button at the top of the Spray Monitor Configuration window.
Touch the Trigger Mode button and set the mode to Intermittent or Continuous.
