Touch the information and setup bar on the Spray Controller faceplate.
Select Spray Controller Configuration from the drop-down menu.
One Spray Controller module is used for each MEG or A20A and CleanSpray gun combination. Each Spray Controller module consists of a driver board and a timer board, providing trigger timing and coil driver voltage for the spray guns.
Spray Controllers must be set up by your Nordson representative. Contact your Nordson representative to change these settings.
The Spray Controller settings must be configured before starting production. The settings consist of Spray Controller names, lacquer spray gun timing, CleanSpray gun timing, and faults.
Touch the information and setup bar on the Spray Controller faceplate.
Select Spray Controller Configuration from the drop-down menu.
Or:
Touch the Tools button on the main button bar.
Select Configure Spray Controllers from the drop-down menu. A list window opens.
Select the Spray Controller you want to configure from the list.
Touch this button.
NOTE: You can only access the Copy Spray Controller Configuration from the controller faceplate Information and Setup bar.
