The iTrax system notifies the operator if a fault occurs. Faults are grouped according to severity or frequency into Warnings or Alarms. Fault levels for operating parameters are set from the module configuration screens.
NOTE: Faults must be enabled in order for the OI to generate a fault.
If a fault occurs, the following change to Yellow (Warning) or Red (Alarm)
main button bar background,
fault status bar on affected module faceplate,
information and setup bar on affected module faceplate.
On affected modules, the yellow or red LEDs light.
Refer to Fault Messages and Resolutions for a list of fault messages and suggested resolutions.